WaveLab 7: normalisere niveauer - hvordan det fungerer
Med Wavelab kan du normalisere niveauet for hele lydfiler eller sektioner i bare et par trin. Vi fortæller dig, hvordan det fungerer.
Normaliser niveauer i Wavelab 7
Undertiden er lydfiler for stille eller antages at have den samme maksimale lydstyrke til bestemte formål. Derefter skal du normalisere dine lydfiler. Det er let at gøre i Wavelab. Du kan finde detaljerede tip i billedgalleriet:
- Åbn den ønskede lydfil eller flere filer.
- I den aktive lydfil markeres det område, du vil normalisere.
- Tasten [N] fører dig til normaliseringsmenuen.
- Her kan du først lade Wavelab bestemme det aktuelle topniveau.
- I området "Ønsket topniveau" skal du indtaste den værdi, du vil normalisere niveauet til.
- Med et klik på "Anvend" starter normaliseringen, det betyder, at det markerede område ganges med den faktor, der bringer topniveauet til den ønskede værdi.
- Hvis du gemmer filen nu, gemmes filen med det justerede niveau.
Yderligere praktiske tip fortæller dig, hvordan du opretter lydmontager og gemmer dem som MP3.
Seneste videoer
Start Wavelab, og åbn den ønskede lydfil via »File«, »Open« eller ved at klikke på mappesymbolet øverst til venstre.
Wavelab kan åbne en række lydformater, såsom WAV, MP3, AAC, nogle af dem også fra videoformater, såsom AVI. Du kan se, om Wavelab kan åbne det ønskede format ved at trække og slippe filen ind i det grå område af Wavelab-vinduet.
Efter åbning af filen vises bølgeformen. Marker det område, du vil normalisere her. Hvis du vil normalisere hele filen, skal du vælge den med [Ctrl] + [A].
Opkald via »Lydredigering«, »Normaliseringsniveau
«Normaliseringsmenuen. Åbn det alternativt ved at trykke på [N] -tasten.
Nu kan du først bestemme den aktuelle topværdi af din markering.
Dette normaliseres til den værdi, du indtaster i feltet "Ønsket topniveau". Du kan normalisere til en værdi mellem -60dB og 0dB, Wavelab tilbyder ikke lavere niveauer. Med et klik på "anvend" udføres normaliseringen.
Hvis du vil normalisere jævnligt til et vist niveau, kan du indtaste det og gemme det som en forudindstilling ved at klikke på arkiveringsskabet. Fra nu af kan du vælge dette under "Forudindstillet
Load".
I modsætning til VST- eller Direct-X-effekter er en beregning, den såkaldte "rendering" ikke nødvendig. Gem blot med [Ctrl] + [S] eller via »File«, »Save as
".